Please note that the club forum is no longer active and is only visible as an archive.
Information is now sent out via our various alternative means of communicating through our WhatsApp group, Facebook page, the core web site and, of course, club nights and at events face to face.
Jeep amongst the Landy pack )
-
Zedman
- Posts: 440
- Joined: Mon Feb 08, 2010 9:19 pm
- Location: Knaresborough
- Full Name: Richard Bentley
Jeep amongst the Landy pack )
Also done a few minor mods
1. Made a new front bumper from some scrap, i now have front shackle points, total cost 8p, (i needed some spacers, 2p's were just the right thickness and i needed 4, I was upset I had no washers the right size)
2. Removed anti roll bar, then did road test round my nearest roundabout, cant feel any difference, oh well.
3. CB radio fitted for green laning, not sure if it works cos not many folks have CB radio near by and I strongly suspect my daughter has traded my walkie talkies with her friends for girly stuff.
4. Fitted soft top and then found out it is far quicker to unbolt the hard top and lift it off than fold down the soft top, soft top now in the skip ( it was a bit knackered )
1. Made a new front bumper from some scrap, i now have front shackle points, total cost 8p, (i needed some spacers, 2p's were just the right thickness and i needed 4, I was upset I had no washers the right size)
2. Removed anti roll bar, then did road test round my nearest roundabout, cant feel any difference, oh well.
3. CB radio fitted for green laning, not sure if it works cos not many folks have CB radio near by and I strongly suspect my daughter has traded my walkie talkies with her friends for girly stuff.
4. Fitted soft top and then found out it is far quicker to unbolt the hard top and lift it off than fold down the soft top, soft top now in the skip ( it was a bit knackered )
-
Bo
- Posts: 682
- Joined: Sat Jan 27, 2007 6:35 pm
- Location: WF10
- Full Name: Scot Chegg
I think this section covers it:
E.1.1. All vehicles must be in one of the following two configurations:-
E.1.1.1. Soft-top vehicles - must have the manufacturer’s windscreen raised, and complete manufacturer’s hood and support structure in place. The rear flap on the tilt may be secured open.
E.1.1.2. Hardtop vehicles must have the whole of the manufacturer's hardtop or truck cab with all fastenings secured and all glass in position.
E.1.1. All vehicles must be in one of the following two configurations:-
E.1.1.1. Soft-top vehicles - must have the manufacturer’s windscreen raised, and complete manufacturer’s hood and support structure in place. The rear flap on the tilt may be secured open.
E.1.1.2. Hardtop vehicles must have the whole of the manufacturer's hardtop or truck cab with all fastenings secured and all glass in position.
-
Zedman
- Posts: 440
- Joined: Mon Feb 08, 2010 9:19 pm
- Location: Knaresborough
- Full Name: Richard Bentley
Bigger problem is the hole in the radiator
The bigger problem is the hole in the radiator, anyone know if there is a repair service in the Knaresborough area for aluminium radiators ?
-
jim
- Posts: 307
- Joined: Sun Jan 07, 2007 8:53 am
- Location: Harrogate
- Full Name: James Poulton
There is an advert on ebay that do jeep radiators and are located south yorkshire:
http://cgi.ebay.co.uk/JEEP-CHEROKEE-4-0 ... 439f22a08e
http://cgi.ebay.co.uk/JEEP-CHEROKEE-4-0 ... 439f22a08e
-
Zedman
- Posts: 440
- Joined: Mon Feb 08, 2010 9:19 pm
- Location: Knaresborough
- Full Name: Richard Bentley
Finaly got it off
Finaly got it off, one of the cores had a crack in it, the good news is its not ali as I thought its brass, so lots of solder later it looks like its fixed, off for a short test run to get it up to temp, if alls good I am heading over to RHB )
Who is online
Users browsing this forum: No registered users and 1 guest