Endfloat
Endfloat
In preparation for rebuilding the front axle internals with the new halfshafts I've been thinking about how to sort out the end float and I've got a few questions:
1. How crucial is it to have endfloat within the tolerances set in the spec (according to Haynes in should be 0.12 - 0.25mm).
2. I've not got a dial gauge so could I just use feeler gauges?
3. Any other tips for setting endfloat?
Cheers
Mark
1. How crucial is it to have endfloat within the tolerances set in the spec (according to Haynes in should be 0.12 - 0.25mm).
2. I've not got a dial gauge so could I just use feeler gauges?
3. Any other tips for setting endfloat?
Cheers
Mark
Who is online
Users browsing this forum: No registered users and 8 guests