Please note that the club forum is no longer active and is only visible as an archive.
Information is now sent out via our various alternative means of communicating through our WhatsApp group, Facebook page, the core web site and, of course, club nights and at events face to face.
Endfloat
-
varleym
- Posts: 414
- Joined: Wed Feb 17, 2010 4:42 pm
- Location: Harrogate
- Full Name: Mark Varley
Endfloat
In preparation for rebuilding the front axle internals with the new halfshafts I've been thinking about how to sort out the end float and I've got a few questions:
1. How crucial is it to have endfloat within the tolerances set in the spec (according to Haynes in should be 0.12 - 0.25mm).
2. I've not got a dial gauge so could I just use feeler gauges?
3. Any other tips for setting endfloat?
Cheers
Mark
1. How crucial is it to have endfloat within the tolerances set in the spec (according to Haynes in should be 0.12 - 0.25mm).
2. I've not got a dial gauge so could I just use feeler gauges?
3. Any other tips for setting endfloat?
Cheers
Mark
Who is online
Users browsing this forum: No registered users and 1 guest